- New
Wifi / Ethernet external module
A Wifi / Ethernet external module is used to provide WLAN / Ethernet data services. Wifi supports the 802.11 b / g / n wireless standard and the 2.412G-2.484G frequency range. There are two modes of operation for the user, AP mode and STA mode: STA mode is selected if only one inverter needs monitoring by the Wifi / Ethernet module; the opposite, AP mode should be selected if there is more than one inverter that needs monitoring. However, one of the inverters must be configured as a service provider access point via a WLAN or you need a router to assign an IP using the Ethernet protocol. The settings of the router and the wireless access point are the same. The IP address should be set as 10.10.1.254. Internal parameters can be set via the browser.
A Wifi / Ethernet external module is used to provide WLAN / Ethernet data services. Wifi supports the 802.11 b / g / n wireless standard and the 2.412G-2.484G frequency range. There are two modes of operation for the user, AP mode and STA mode: STA mode is selected if only one inverter needs monitoring by the Wifi / Ethernet module; the opposite, AP mode should be selected if there is more than one inverter that needs monitoring. However, one of the inverters must be configured as a service provider access point via a WLAN or you need a router to assign an IP using the Ethernet protocol. The settings of the router and the wireless access point are the same. The IP address should be set as 10.10.1.254. Internal parameters can be set via the browser.
A Wifi / Ethernet external module is used to provide WLAN / Ethernet data services. Wifi supports the 802.11 b / g / n wireless standard and the 2.412G-2.484G frequency range. There are two modes of operation for the user, AP mode and STA mode: STA mode is selected if only one inverter needs monitoring by the Wifi / Ethernet module; the opposite, AP mode should be selected if there is more than one inverter that needs monitoring. However, one of the inverters must be configured as a service provider access point via a WLAN or you need a router to assign an IP using the Ethernet protocol. The settings of the router and the wireless access point are the same. The IP address should be set as 10.10.1.254. Internal parameters can be set via the browser.
