This device protects electrical devices from power surges. The protection device attempts to limit the voltage applied to the electrical device by blocking or short-circuiting any unwanted voltages above the safe level.

The UPS in a special cabinet with IP65 and IP55 protection is used in the temperature range from -30 ° C to + 50 ° C.

This device is physically connected to the UPS with a cable and allows for remote monitoring and control of the system. The panel can be installed up to 500 meters from the UPS and will be powered by an interface cable.

Fastening elements are the ideal tool for fastening UPS or battery modules in a 19 ”rack cabinet. In addition, the sliding function (quick removal of the module) provides very easy and quick access to the cabinet.

The relay card is based on dry contacts and gives a signal in the following cases: interruption of power supply, switching to bypass or common errors. AS400 and Modbus cards provide an interface to the appropriate protocols.

External and internal chargers for high-capacity batteries and with faster charging time.

The NetFeeler sensor is mainly used in the server cabinet and for monitoring the room. They can inform you about the temperature and humidity through an IP address. Sensors can also be connected to the three ports of an SNMP adapter, which is attached to various TSL UPS series.

The electrical circuit, “before” and “after” of the galvanically isolating transformer, is connected with each other not by conductors, but by an electromagnetic field. This increases the reliability of protection. Peaks and power surges cannot pass through a galvanically isolated transformer.

A Wifi / Ethernet external module is used to provide WLAN / Ethernet data services. Wifi supports the 802.11 b / g / n wireless standard and the 2.412G-2.484G frequency range. There are two modes of operation for the user, AP mode and STA mode: STA mode is selected if only one inverter needs monitoring by the Wifi / Ethernet module; the opposite, AP mode should be selected if there is more than one inverter that needs monitoring. However, one of the inverters must be configured as a service provider access point via a WLAN or you need a router to assign an IP using the Ethernet protocol. The settings of the router and the wireless access point are the same. The IP address should be set as 10.10.1.254. Internal parameters can be set via the browser.

The external manual bypass module (single phase and three phase) is intended for service or other work without disconnecting the load from the power supply. The UPS can be turned off after the power is switched to the bypass line. All TSL STS / ATS series devices can also be used as an external bypass.

SNMP adapters provide UPS monitoring over local or wireless networks, including email notifications. Monitoring software allows you to connect to the IP address of each UPS. For example, all servers on the network may be down. At the same time, SMS can be sent without connecting to a LAN network using a GSM modem.

GPRS / IP based remote server controller with internal web server system. It can be used in conjunction with an inverter or solar power generator to the analyzer wind speed and other operating conditions